Insulating the floor of your loft will keep your house warmer – trapping heat in the main part of the home. However, this makes the loft space colder and so water pipes in the loft are more prone to freezing. Protect these pipes by lagging them.
Lagging simply means adding insulation to the water pipes and is easy to do with foam tubes. It prevents them freezing and also helps any exposed hot water pipes retain their heat when running through unheated parts of the house.
In this guide we’ll provide step-by-step advice on how to:
Before tackling any loft project, head to our guide on loft safety.
It includes essential advice on how to move and work safely in the loft, as well as a full list of recommended protective clothing and other loft project must-haves. These items are not included in this article's list of materials and tools. Be sure to read and check you have everything you need to safely start insulating water pipes in your loft.
Before you can lag your water pipes, it’s essential to measure their size. This will ensure you buy the right size of tubing to best fit. This means a trip into the loft.
If lagging water pipes as part of a loft floor insulation project, we recommend doing this before laying any insulation. This is because it can be difficult to access, measure and insulate water pipes once covered.
In the loft, measure and note the diameter (width) of a visible length of pipe (as illustrated).
Our pipe insulation is available to fit three sizes of pipe diameter – 15, 22 or 28millimetres (mm). Choose the size that best fits your pipes.
Measure and note the length of visible pipes to total an approximate length of pipe needed.
Our pipe insulation comes in two lengths – 1 or 2metres (m). Choose lengths that best suit how your pipes are configured.
We recommend buying an extra length of pipe as it’s best to have too much than not enough.
With the pipe insulation chosen, it's time to lag the water pipes.
Open a length of pipe insulation along the pre-marked split and slide it onto the pipe. If you have pipes coming up through the loft floor or running along the joists, fold back the loft insulation, fit the pipe tube and then put the insulation back in place.
Continue insulating the whole length of the pipe run.
When you come to a bend in a pipe, cut the pipe insulation to ensure a close, tight join.
To do so, place the length of pipe insulation in a mitre box and cut a 45-degree angle with a tenon saw.
Butt the two cut lengths as close together as possible and tape the join using duct tape to ensure minimal heat loss.
If you have a stopcock (as shown) or any other obstruction like a tee joint, make a cut to one side of it. Then make a horizontal cut so the pipe insulation can wrap around the object.
Cut and place a small length of pipe tube over the tap handle and cover it with tape to hold it in place.
Continue to lag all the pipes until they’re all insulated.
If you also have a cold water tank, we recommend insulating that as well as your water pipes. For advice on this, head to our guide.