23 people bought this in 48 hours
Spruce Tongue & groove Cladding (L)3m (W)119mm (T)14.5mm
Product details
Product information
Tongue and groove cladding can be fixed in either a vertical or horizontal position. When installing vertically start the project in one corner of the room with the groove side of the board facing the adjoining wall. Cladding can be adhered to a smooth surface or stud work or fixed to timber battens. Cladding can be face fixed or secret fixed by nailing through the base of the tongue at an angle into the stud, wall or batten. When fitting the last board this may need to be trimmed to fit by removing a section from the tongue side of the cladding. If a tight fit the under section of the groove of the cladding can be cut away so the board fits neatly on the tongue of the previous board. This must be glued or face fixed. When fitting cladding in a horizontal position begin with the lowest cladding board at the bottom of the project with the groove nearest the ground, this can also be fixed onto the surface by nailing at an angle through the base of the tongue. Work upwards and complete the project with the last board being cut to fit if necessary.
- Seal cut edges with a suitable treatment when used externally
Features and benefits
- Precision finished
- Preservative treated
- Slow grown & kiln dried to make it more stable & easier to work with
- Precision finished
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
DetailsSpecifications
| Colour group | Natural |
|---|---|
| Length (m) | 3m |
| Location | External |
| Material | Spruce |
| Pack quantity | 1 |
| Thickness (mm) | 14.5mm |
| Weight (kg) | 3.92kg |
| Width (mm) | 119mm |
| Product code | 5397007203080 |
Reviews
3.36 / 5(41 reviews)Little Neil - 1 / 5 - 23/04/2025
Poor quality
Should have listened to the other reviewers. Only bought 3 lengths. Two came with 8 inch splits at the end and the other piece was full of knots. Just manged to wangle a finish out of it. As if whoever selected items was getting rid of the substandard stuff as ordered online and to be delivered unseen. Be warned.
Cleish - 4 / 5 - 01/04/2025
Substantial cladding
The fist delivery came with a part of the tongue of one board missing (hence the 4 stars) but BandQ were quick to send a replacement. It is substantial for cladding and I am happily using it to make a shed door.
FHS - 4 / 5 - 21/03/2025
Successful job complete
Absolutely did the job I needed it too, would buy again.
flyingal - 5 / 5 - 07/02/2025
Shed repair
Very well finished and treated. I recommend these boards for replacing shed boards.
Bn5 - 4 / 5 - 07/02/2025
Great quality treated cladding
Purchased this cladding to make replace my doors for refurbishing a shed. Great for the job but had to exchange one length that had a large knot hole in it
FrankieKen - 5 / 5 - 27/08/2024
Very Content
Item was ready for when I arrived and was in a good state and it matched, just what I needed to fix a panel on my shed. Very content with the purchase.
Garden - 5 / 5 - 10/05/2024
Perfect foundation for my polytunnel
I bought these boards hoping that they would work for my polytunnel project. They were perfect in every way after making them weatherproof.
Torbyian - 3 / 5 - 30/11/2023
Too many knots
I wasn't expecting quite so many knots in the wood I received, fortunately I had knotting solution in , of which I had to apply a fair bit, also I had to cut end sections off that had knots.its fair to say not as good as hoped. Much It just made the job longer and harder than expected.
MercianShine - 3 / 5 - 23/11/2023
Good quality
Straight board, no troublesome knots. Treatment seems good
BtnBob - 2 / 5 - 07/11/2023
Useless, the tongues and grooves don’t mate up
I had 42 pieces delivered last spring but didn’t get round to using them until this week. The pieces were stored in the garage so we’re nice and dry. It is almost impossible to get the tongues and grooves to mate up. I have spent (wasted) two days trying to fit 2.4 metre lengths together onto the shed and only managed fit eight of them. I have now given up. A waste of money.