Volden Repair Render compound, 10kg Tub - Requires mixing before use

Product information

Volden render repair is suitable for repairing, patching and maintaining external render and is perfect for repairing weather and impact damage A quick and easy solution to do small work repairs, like wears or impact damages. Comes with 2 x 5kg bags to allow you to mix for multiple jobs on different days

• Guarantee - Statutory
• Resistant to chemicals & frost. Weatherproof
• Adjacent surfaces that may be damaged during the rendering application should be suitably protected. Substrates must be clean and free of gypsum, paint, other coatings, organic growth, salts and efflorescence. The substrate should be level and plumb to allow a uniform thickness of render to be applied. Recommended ambient application temperature is 5°C to 25°C 1) Remove existing loose or damaged render with a hammer and chisel. 2) Brush the surface to remove any loose material and vacuum the area to remove any dust. 3) Prior to application, surfaces should be roughened and thoroughly dampened with clean water. Ensure any pooled surface water is removed. 4) Open the bucket, remove internal bag. Fill bucket bucket to the desired volume with clean water. Approximately 0.8-1 litres of water are required per 5kg. Mix thoroughly. 5) When the mix is stiff enough to remain on your trowel when it's turned upside-down, you are ready to render. The working life is approximately 30 minutes after mixing at 20°C (dependent on ambient conditions). 6) You can reduce waste by saving any unused product. Just fill the tub with water and submerge the remaining product and replace the lid firmly. If stored in the recommended conditions, the product should keep soft and useable for up to a month. 7) Cure times are dependent on temperature and humidity, but as a guide the product can accept foot traffic 12 hours from installation. Please note that cold temperatures and wet weather can delay the curing time significantly. 8) Protect compound from inclement weather conditions and direct sunlight until cured. In warm weather, apply a fine spray of clean water to prevent the repair from drying out too quickly. 9) Clean tools and equipment with warm soapy water immediately after use. 10) Fully cured after approximately 7 days at 20°C (depending on mortar thickness and drying conditions). Once cured, the surface is paintable.
• General purpose render repair applications
• Contains Portland Cement Danger Causes serious eye damage. Causes skin irritation. May cause an allergic reaction. May cause respiratory irritation. Keep out of reach of children. Wear protective gloves/protective clothing/eye protection/face protection. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTRE or doctor/physician/ Wash with plenty of soap and water. If skin irritation or rash occurs: Get medical advice/attention. Avoid breathing dust/fumes/gas/mist/vapours/spray. IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTRE or doctor/physician. Skin contact with wet mortar may cause irritation, dermatitis or burns. May cause damage to products made of aluminium or other non-noble metals. Harden by application of water and dispose of concrete waste. Dispose of contents/container according to local regulations Refer to product SDS

Features and benefits

• A convenient method for completing small render repairs
• Easy to use water fill markings inside the tub
• Ready to use, just add water and mix in the tub
• Ready to paint over when dry
• 10kg will produce enough render to cover 30 bricks at 10mm thickness
• Includes 2 x 5kg Bags