Safety Instructions When using electrical products, basic safety precautions should always be followed. Check that the voltage indicated on the rating plate corresponds with that of the local network before connecting the product to the mains power supply. Children younger than 3 years old should be kept away from the product unless continuously supervised. Children aged from 3 years and less than 8 years should only switch on/off the product, provided that it has been placed or installed in its intended operating position and they have been given supervision or instruction concerning the use of the product in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years should not plug in, regulate or clean the product or perform user maintenance. Children aged from 8 years and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge can use this appliance, only if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children should not carry out cleaning or user maintenance without supervision. Children should be supervised to ensure that they do not play with the product. This product is not a toy. This product contains no user serviceable parts. If the power supply cord, plug or any part of the product is malfunctioning or if it has been dropped or damaged, only a qualified electrician should carry out repairs. Improper repairs may place the user at risk of harm. Keep the product and its power supply cord out of the reach of children. Keep the product and its power supply cord away from heat or sharp edges that could cause damage. Keep the power supply cord away from any parts of the product that may become hot during use. Keep the product away from other heat emitting products. Keep furniture, curtains and other flammable material at least 1 metre away from the product. Do not run the supply cord under carpets, rugs etc. or anywhere where it may present a trip hazard. Do not immerse the product or plug in water or any other liquid. Do not operate the product with wet hands. Do not use this product in the immediate surroundings of a bath, a shower or swimming pool. Do not leave the product unattended whilst connected to the mains power supply or when in use.
Do not remove from the mains power supply by pulling the cord; switch off and remove the plug by hand. Do not use this product for extended periods of time. Do not use the product for anything other than its intended use. Do not cover this product. Do not block the air intake of the product; place in an open, well-ventilated space. Do not use this product outdoors. Do not attempt to move the product whilst it is in use. Do not touch the product during use, as it will get very hot and could cause injury. Do not use the product with a programmer, timer, separate remote-control system or any other device that will switch the product on automatically, as there is a risk of fire if the heater is covered or positioned incorrectly. Do not clean the product with abrasive chemicals or materials such as scourers as they may damage the product and impair future function. Do not lift the product by the front panel. The product should be used on a stable, heat-resistant surface. The product must not be located immediately below or next to a mains power supply. Always unplug the product after use and before any cleaning or maintenance. Always ensure that the product has cooled fully after use, before any cleaning or maintenance. Never use accessories that are not recommended or supplied by the manufacturer. It could cause danger to the user and damage to the product. Use of an extension cord with the product is not recommended. This product is intended for domestic use only. It should not be used for commercial purposes.
Caution: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. Hot surface – do not touch the hot section or heating components of the product. Warning: In order to avoid overheating, do not cover the product. This product is not equipped with a device to control the room’s temperature. Do not use this product in small rooms whilst occupied by persons incapable of leaving the room on their own, unless constant supervision is provided. Normal voltage is still present in this product as long as the product is connected to the electrical source. Always unplug the product when not in use. In order to avoid a hazard, due to inadvertently tripping the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, nor should it be connected to a circuit this is regularly switched on and off by the utility.
Battery Safety (Remote Control Only) Check that the battery compartment is secure. Only batteries of the same or equivalent type as those recommended should be used with this product. Batteries are to be inserted with the correct polarity. Replace a full set of batteries at any one time. Remove any batteries from the product when it is not being used for a long period of time to avoid leakage. Exhausted batteries should be removed from the product to avoid leakage. In the event of batteries leaking, do not allow any liquid to come into contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice. Keep batteries out of the reach of children. Non-rechargeable batteries should not be recharged. Rechargeable batteries must be removed from the product before being charged. Rechargeable batteries should only be recharged under adult supervision. The supply terminals are not to be short-circuited. Exhausted batteries must be removed and disposed of safely. Do not dispose of batteries in a fire. Do not crush, puncture, dismantle or otherwise damage the batteries. Do not expose batteries to heat or fire as they may explode. Do not mix alkaline, standard (carbon zinc) and rechargeable batteries (nickel hydride). Do not subject the batteries to mechanical shock. Do not dispose of batteries in household waste. To dispose of any batteries, take them to a local recycling station. Contact the local government offices for details. This product requires a CR2025L battery (not included).
Thermal cut-out device The wall fire is fitted with a thermal safety cut-out device, built in to prevent it from overheating. Should the wall fire start to overheat, the thermal safety cut-out system will automatically operate, and the heat settings will switch off. If this happens: STEP 1: Switch off the wall fire using the on/off switch. STEP 2: Unplug the wall fire from the mains power supply and allow it to cool for approx. 15 minutes. STEP 3: Clear any blockages present on the vent, being careful not to damage the wall fire. STEP 4: Plug in and switch on the wall fire at the mains power supply. CAUTION: In order to avoid a hazard, due to inadvertent resetting of the thermal cut-out, this wall fire must not be supplied through an external switching device such as a timer or connected to a circuit that is regularly switched on and off by the utility. Care and maintenance Always unplug the wall fire from the mains power supply and allow it to cool sufficiently before performing any cleaning or maintenance. Wipe the exterior of the wall fire with a soft, damp cloth and allow to dry thoroughly. Do not use harsh or abrasive cleaning solvents or scourers, as they may damage the finish of the wall fire. The flat glass fascia should be cleaned carefully with a soft cloth; do not use proprietary glass cleaners.
