Whether you’re still on a job or stocking up for the next, we'll be open until 8pm bank holiday Monday for everything you need.
See more Paint
Zinsser Watertite White Matt Interior & exterior Waterproofing paint, 5L
Product details
Product information
WaterTite® Waterproofing Paint is guaranteed to keep water out and contains a biocide that protects the dried coating against fungal degradation, making this a great solution for surfaces where this can be problematic. It can easily be applied to wet or dry surfaces, creating a smooth, non-gritty finish. Made with a unique solvent-based formula that combines a state-of-the-art waterproofing resin with Portland cement to create a coating that stops up to 34psi of water pressure. WaterTite® Waterproofing Paint can be applied to dry, damp or wet surfaces, so water problems can be cured immediately. It can be recoated in just four hours and dries to a smooth, bright white, non-yellowing finish that resists dirt and dust pick-up.
- Instructions for Use - To ensure against accumulation of solvent vapours, be sure to open all windows and doors. Use a non-sparking exhaust fan to provide air movement. Extinguish all flames and pilot lights at water heaters and heating systems. Turn off air/heating systems at thermostat. Walls can be damp, but must be free of active water leaks. Stir thoroughly before and during application. DO NOT THIN. Apply when air and surface temperatures are 10°C or higher. Do not apply if heavy rain is expected within 24 hours. Liberally apply the first coat using a thick polyester bristle brush, or by rolling a small section (1m x 1m), and then using a brush to work the coating into the pores of the masonry. Apply as much paint as necessary to produce a continuous, pinhole free film. Use a 20-25mm nap roller for unpainted, porous surfaces, and an 18mm nap roller for smooth or previously painted surfaces. The second coat can be brushed or rolled. Do not over spread. WaterTite® is a two coat system. The first coat primes and seals the surface. The topcoat completes the sealing process to ensure protection against water intrusion. After the second coat has dried, inspect the surface for pin holes, where pin holes are noted apply additional paint as necessary.
Features and benefits
- Guaranteed to stop up to 34psi of water pressure
- Prevents fungal and algal degradation on the paint film
- Smooth, non-gritty finish applies easily to wet or dry walls
- Adheres to any interior or exterior masonry surface
- Ultra low odour formula
- Formulated to prevent recurring efflorescence on concrete and brickwork
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
Specifications
Brand | Zinsser |
---|---|
Application method | Brush or roller |
Base | Solvent-based |
Colour | White |
Container type | Tin |
Coverage | 10m² |
Drying time | 14 days |
Finish | Matt |
Location | Interior & exterior |
Minimum touch dry time | 1h |
Number of coats | 2 |
Paint type | Treatment |
Recoat time | 4 hours |
RGB value | 255,255,255 |
Room use | Cellar & basement |
VOC level | High |
Volume | 5000ml |
Product code | 5037898610412 |